What we repair

We are an independent company servicing one manufacturer. That is a deliberate limit rather than a gap: knowing one line of equipment well beats knowing six badly, and it means the service positions, the access constraints and the parts on the van already match the appliance in the opening. Whichever of these pages brought you here, the visit runs the same 6 stages in the same order.

• Built-in refrigeration

  Sub-Zero Built-In Refrigerator Repair in Nocatee

  Two refrigeration circuits in one cabinet, a condenser working against Florida heat, and a door heavy enough to change its own geometry.

• Sealed systems

  Sub-Zero Sealed System Repair in Nocatee

  Compressor, condenser, evaporator and refrigerant faults — measured last, because five cheaper stages can each make a healthy circuit look sick.

• Integrated columns

  Sub-Zero Integrated Column Repair in Nocatee

  Panel-hung doors, hinge and closer wear, and two cabinets side by side that share nothing but the joinery they are set into.

• Undercounter units

  Sub-Zero Undercounter Repair in Nocatee

  Toe-kick airflow, island heat, drawer runners and a drain path that ends under the compressor — the faults that come with putting refrigeration in a base cabinet.

• Wine storage

  Sub-Zero Wine Storage Repair in Nocatee

  No water connection, no ice, no defrost drama — and four faults that quietly put a dual-zone cabinet out of specification without ever raising an alarm.

• Ice makers

  Sub-Zero Ice Maker Repair in Nocatee, FL 32081

  Cube size is a symptom, not a diagnosis. Fill volume is measured with a vessel and a stopwatch, and the freezer compartment is checked before any valve is quoted.

• Filters and dispensers

  Sub-Zero Water Filter and Dispenser Repair

  A cartridge is rated in gallons, not months. Where flow has dropped, the restriction is found by measurement — filter, valve, supply or dispenser line.

Every one of these visits starts the same way: $129 flat, measurements before opinions, and a written estimate you approve before a part is ordered. Completed work carries 90 days on labor and 365 days on parts. See warranty terms or the common questions.